Aligning Plus/Minus Symbols

For scientific writing numeric data are often presented in tables in the format of mean +/- standard deviation (with the '+/-' represented by a single character, achieved by holding down the Alt key and press 0177 on the numeric keypad). To make the table look attractive, it is often desirable to have the +/- symbols of different rows aligned with each other.

There are a couple of ways you can align the symbols, depending on the characteristics of the data you are presenting. One solution is to use multiple columns in your table, so that the +/- character appears in its own column. Format the column to the left of the +/- column so that the numbers it contains are right-aligned. Format the +/- column so that it is left-aligned. The information in the two columns should now be butted up to each other, and you can adjust the apparent spacing between them by selecting the columns and choosing Table | Table Properties | Table tab | Options. Adjust the Left and Right cell margins to get the desired spacing between the number and the +/- symbol. You can then use Format | Borders and Shading to remove the table line that appears between the number and the symbol.

If all this sounds like a lot of steps, it really can be--it depends on exactly how you want the information in the two columns to look. A simpler solution might be to simply set tab stops within the column itself. If there is no decimal point within the +/- numbers, then you can set a decimal tab in the column. Word automatically aligns the values as if the +/- symbol was really a decimal point.

If the values do have decimal points, then you can set multiple tabs within the column, and then use Ctrl+Tab to actually insert the tab character before the number (to align the number) and between the value and the +/- symbol (to align the symbol).

Unless the data absolutely must be in a table, you should also consider using the Equation Editor to represent the +/- values. The Equation Editor has an alignment mark--a non-printing symbol located on the second palette on the top row of Equation Editor palettes. Just place an alignment mark either to the left or to the right of the +/- symbol, and press Enter at the end of each number. It doesn't matter if the alignment mark is to the left or to the right of the +/- symbol, as long as you're consistent for each number.